Re-Purposing a Hot and Cold water Dispenser
Posted: Wed Oct 07, 2015 10:50 am
You seen them in offices, those nice units that sell of about 200 to 300 bucks that dispenses hot and cold water and some elite units has a center spout for warm water.
Well I connected mine up to the inverter and got hot water and to boot it was using 3 bars for cooling the water and heating the water, after the water heater kicked off it was down to using 1 bar.
so here it is mi idea for a DIY and possibly your answer troy to getting both hot and cold water in one simple package.
I found this unit at a garage sale for 40 bucks.
so what can I do with some pex and a shower head?
might have to take short bursts ..but..hey...
would it work..oh and for safety, I would turn the hot water heater's temp down to about 120.
I will have to add the pic later as I get "The file is too big, maximum allowed size is 256 KiB."
I will try this then
https://youtu.be/VP5hlrmqA80
Well I connected mine up to the inverter and got hot water and to boot it was using 3 bars for cooling the water and heating the water, after the water heater kicked off it was down to using 1 bar.
so here it is mi idea for a DIY and possibly your answer troy to getting both hot and cold water in one simple package.
I found this unit at a garage sale for 40 bucks.
so what can I do with some pex and a shower head?
might have to take short bursts ..but..hey...
would it work..oh and for safety, I would turn the hot water heater's temp down to about 120.
I will have to add the pic later as I get "The file is too big, maximum allowed size is 256 KiB."
I will try this then
https://youtu.be/VP5hlrmqA80