The DIY World Store





(Low RPM) Permanent Magnet Generator / Alternator

Discussions about solar, wind and radiant energy. Electronics and projects dealing with energy savings.

(Low RPM) Permanent Magnet Generator / Alternator

Postby gabrielm » Fri Feb 27, 2015 12:32 pm

Hi all,

Can anyone help me with the diagram of construction (+ how to construct & what material to use) for an alternator with the following specs ?

-->
a) 240 Volts
b) max 50 RPM
c) 50 Hz
d) max. continuous load of 15kW

i understand this would mean some 120 poles..

thanks...gab
gabrielm
 
Posts: 1
Joined: Fri Feb 27, 2015 12:07 pm

(Low RPM) Permanent Magnet Generator / Alternator

Sponsor

Sponsor
 

Re: (Low RPM) Permanent Magnet Generator / Alternator

Postby techman » Sat Feb 28, 2015 11:48 am

That is over my head. I know there are formulas for calculating and estimating a generator output before you make it but I also understand that it is some tough calculations. Over my head.

Anyone else out there?
techman
Site Admin
 
Posts: 1308
Joined: Thu Dec 22, 2011 11:49 am

Re: (Low RPM) Permanent Magnet Generator / Alternator

Postby diyharbor » Wed May 13, 2015 4:01 pm

i did a video on a whole build of an axial flux alternator for a wind turbine, it might help you out a little bit
https://www.youtube.com/watch?v=fCthR5u2sCY
diyharbor
 
Posts: 1
Joined: Wed May 13, 2015 3:58 pm

Re: (Low RPM) Permanent Magnet Generator / Alternator

Postby gadgett840 » Fri Mar 04, 2016 10:47 pm

hi im new and no expert but the herts would be a factor of the operational speed and iv never seen a gen with more than 44 poles. the poles can have more than one coil in it. im building a gen now, well in the designing stages. the outside diameter is a large factor for a slow speed gen. pay close attention to the surface speed of the magnets compaired to the diameter at the center of the magnets. good luck. an hour worth of studying can make or brake the hole project.
gadgett840
gadgett840
 
Posts: 4
Joined: Fri Mar 04, 2016 9:51 pm


Return to Alternate Energy Discussions

Who is online

Users browsing this forum: No registered users and 2 guests

cron